Three Li+ internal standard tube, one hundred 2-mL sample vials, ten 14-mL sample vials, and a 6-ft power cord.
This autosampler provides a fully automatic analysis solution for your long sample runs - designed to work specifically with both the dual-channel and four-element flame photometers. The autosampler fits within the dimensions of the automatic dilutor (02657-00) providing the smallest footprint available, saving valuable bench space.
Operation is simple – press the “Blank” and “Calibrate” keys on the flame photometer and the probe is sent to the blank and calibrated vessels on board the autosampler carousel. The system, after calibration, is ready for the run to begin. Press the “Measure” key and walk away.
The autosampler carries the offering of the relevant sample to the automatic dilutor. Unit features automatic or manual timing settings between samples from the standard 30 seconds to up to six seconds shorter or longer. At the end of the run, defined when the last sample vial is automatically detected, the autosampler emits an audible signal to alert the operator.
Note: This autosampler requires the automatic dilutor (02657-00) for operation. Order software 02656-15 to use the Autosampler with the single-channel flame photometer.
Our specialists are here to help you find the best product or part available for your application. Call or Email us and we will make sure you get the right product or part for the job.